Quantum vmPRO 4000 User's Guide download pdf (Page 110)

Chapter 2: vmPRO Setup and Configuration

vmPRO Advanced Settings

Quantum vmPRO User’s Guide 97

Figure76:Configure Advanced Settings Dialog Box

2. Select the check box next to any of the following settings, as appropriate:

Settings

Enablethefilesystemintegritycheckduringbackup

Select this setting to allow your vmPRO appliance to execute a file system integrity check on VM disks

before performing a backup. See About vmPRO Advanced Settings.

EnableHotAddTransportforallfoldersbydefault

Select to enable HotAdd Transport for all folders within your vmPRO appliance. See HotAdd Transport and

Your vmPRO Appliance.

Skipreadingofpagefileandswappartitionsduringbackup

For improved overall disk I/O savings during a SmartMotion backup, select this setting to enable Progressive

Optimization to skip reading blocks of data associated with temporary, transitional files

on VMs. See About

vmPRO Advanced Settings.

AllowaSmartMotionbackuptorunevenifthesamepolicyisalreadyrunning

Select this setting to do the following:

l Start another scheduled SmartMotion backup of a policy even if that same policy is currently running.

l Start another SmartMotion backup immediately after a long running backup – more than 24 hours – has

completed.

This method is not the preferred backup method, and is not enabled by default.

Examples include virtual memory paging files and temporary files created during software installation.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 240 241

No comments

Quantum vmPRO 4000 User's Guide Page 110