Chapter 3 Quantum Scalar 50 Remote Management
Setup
Quantum Scalar 50 User’s Guide 91
SCSI/Fibre 3
This section allows the user to set the SCSI IDs for the changer (library)
and every tape drive within the library and also configure any Fibre
Channel tape drives.
1 To access the
SCSI/Fibre page, from the Setup page, click on the SCSI/
Fibre
tab at the top of the page.
The
SCSI/Fibre page displays (see figure 63).
Figure 63 SCSI Page
2 To change a SCSI ID, enter the ID number in the field next to the
device and click
Apply.
Note: You can also de
termine the tape drive firmware revision from
the
SCSI/Fibre page.
Note: SAS tape drives do not require a SCSI ID and cannot be
configured. Use the default tape drive configuration
information.
Comments to this Manuals