Appendix C Installing the Scalar 50 Library
Installing the Library
Quantum Scalar 50 User’s Guide 202
a Insert the tape drive into the drive bay slowly until the
connectors are seated (see figure
110).
Figure 110 Scalar 50 Tape
Drive Numbering
b Tighten the tape drive captive screws using a flat blade
screwdriver.
c Repeat
these steps to install another tape drive in a different
location, if desired.
The library chassis is installed in the rack.
Cabling the Library
3
Connect the SCSI cables and jumpers as shown in the following figure:
•
Scalar 50 Cable Configuration (SCSI Full Height Drives)
• Scalar 50 Cable Configuration (Native Fibre Channel Full Height
Drives)
• Scalar 50 Cable Configuration (SCSI Half-Height Drives)
• Scalar 50 Cable Configuration (SAS Half-Height Drives)
Comments to this Manuals