Appendix C Installing the Scalar 50 Library
Installing the Library
Quantum Scalar 50 User’s Guide 210
Figure 118 Setup Screen
12 From the Setup screen, use the up and down arrows to highlight
Cabinet and press Enter.
The Ca
binet screen displays (see figure 119):
Figure 119 Library Options
Screen
13 The Stack role screen allows you to configure the library as a
“Master” or “Slave” in a multiple library stack. The library is
configured “Stand alone” by default. If this is a multiple library stack,
use the up and down arrows to highlight
Stack role and press Enter
displays the following information about the library:
Note: All Scalar 50 libraries must have FULL capacity before
configuration as a stack is possible. PX502 libraries in a
stack are considered fully licensed. Configure each unit
that will be stacked as a stand alone unit and enable
Full
capacity through the remote management pages (see
Library
on page 125). After full capacity is enabled, change
the stack role(s) accordingly to create the multiple library
stack.
Comments to this Manuals