Quantum Q-EKM User's Guide download pdf (Page 50)

Chapter 5 Q-EKM Server Operation and Configuration

Changing the Communication Port Settings

Quantum Encryption Key Manager Service and Installation Manual 37

Changing the Communication Port Settings

Changes the communication port settings on the Q-EKM server. You

should not need to change the default port settings unless the default

ports are being used by other software on the host.

The Q-EKM server is set up with the following ports by default:

• TCP Port (also referred to as the EKM Port) – Default Value 3801

• SSL Port – Default Value 443.

In order for synchronization between the primary and secondary Q-EKM

servers to occur, the TCP and SSL port settings on the primary and

secondary Q-EKM servers must be set to the same values. In order for

library-to-Q-EKM communication to occur, all libraries accessing to the

Q-EKM server(s) must have their Q-EKM port settings configured to the

same values.

The current ports are listed on the Q-EKM commands menu under item

number

7 (see Figure 5 on page29).

To change either of the port numbers:

1 Log on to Q-EKM Commands (see Logging On to Q-EKM

Commands on page 27).

2 At the Enter Command prompt, enter

The Q-EKM server process stops.

3 Press

<Enter>.

4 When prompted, enter

ssl (to change the SSL port) or tcp (to change

the TCP port).

5 Enter the new port number.

The port number is changed.

6 When prompted, press

<Enter>.

The Q-EKM server starts.

7 Press

<Enter> to return to the command menu.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 92 93

No comments

Quantum Q-EKM User's Guide Page 50