Chapter 4: Configuring the Library
Setting the Session Timeout
Quantum Scalar i40 and Scalar i80 User’s Guide 93
Setting the Session Timeout
The library automatically logs out a user or administrative user when the
library has detected no activity for a specified length of time. This
always occurs on the Web client, and will occur on the operator panel if
passwords are enabled (see
Enabling and Creating Passwords on the
Operator Panel on page 83). The default session timeout is 15 minutes.
You can change that to 30, 45, or 60 minutes. You can only change this
setting on the operator panel.
Operator Panel
1 Select Setup > Account Settings > Session Timeout.
The current timeout setting is highlighted.
2 Use the Up and Down buttons to select the desired timeout.
3 Press Apply.
4 Save the library configuration (see Saving the Library Configuration
on page 101).
Configuring System Settings
You can enable/disable the following system settings on the operator
panel:
• Unload Assist
• Logical Serial Number Addressing
• Manual Cartridge Assignment
• SNMP
• SMI-S
Comments to this Manuals