Quantum Scalar i40 User's Guide download pdf (Page 104)

Chapter 4: Configuring the Library

Working With Local User Accounts

78 Quantum Scalar i40 and Scalar i80 User’s Guide

You should not need to change the service port subnet unless it

happens to conflict with the subnet configured for the customer port. If

there is a conflict you must change it to avoid ambiguity between the

two interfaces.

The instructions below explain how to change the IP address on the

service port. You can only change the subnet (third octet) of the IP

address: 192.168.xxx.1. The other sections must remain as they are. You

may choose a number from 1 to 255.

You can only configure the service network from the operator panel.

Operator Panel

1 Select Tools > Service Network.

Under “Modify Subnet” the first digit of the three-digit octet of the

IP address is highlighted.

2 Use the Left and Right buttons to select a digit to modify. Use the

Up and Down buttons to select a value for the digit. When you

press the Right button to the third digit, its function changes to

Apply.

3 When you finish making changes, press the Right button until its

function changes to Apply, then press Apply.

4 Press OK.

5 Save the library configuration (see Saving the Library Configuration

on page 101).

Working With Local User Accounts

Administrative users can create and modify two types of local user

accounts: user and administrative user. These users have different library

privilege levels and can access different things. The Web client requires

user accounts and user logins; the operator panel does not. You can

configure the operator panel to run with no logins required. You can

also configure the library to use Lightweight Directory Access Protocol

(LDAP) accounts.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 327 328

No comments

Quantum Scalar i40 User's Guide Page 104