Chapter 5: Advanced Reporting
Using Advanced Reporting Reports
Quantum Scalar i40 and Scalar i80 User’s Guide 117
Figure 18 Force CPF Screen
3 Select the partition on which you want to force the failover, and
click Apply.
Note: The standby tape drive must be “ready” and “connected”
in order to force a failover.
4 Click Apply.
The new active tape drive location displays in the Active Drive
column. The new standby tape drive location displays in the
Standby Drive column.
Note: If the new tape drive locations do not display, refresh the
browser.
Using Advanced Reporting Reports
The following notes will help you interpret the data listed on the
reports.
• The data for the reports is collected in log files. When the log files
reach their maximum size, the oldest information is deleted as new
information is added. This may affect how much historical data you
can access.
• The on-screen reports contain a chart and a data table. When the
log files are large, it would take an excessively long time to load all
Comments to this Manuals