Quantum 200D/400D User's Guide download pdf (Page 24)

12 Installation

Setting the SCSI ID

The SCSI ID of the LTO standalone may need to be changed, depending upon factors in the setup, operating system, and number of SCSI

devices on the bus. Each device on the bus must have its own address. See Figure 2-2.

Notes

The SCSI ID has been factory preset to 0.

All devices on a SCSI bus must be set to a unique ID.

Figure 2-2 SCSI ID Switch

Note

The LTO standalone can be set to any SCSI ID between 0 and

15.

The SCSI ID switch is located on the rear of the LTO standalone (see Figure 2-2). Use a small pointed object to press either the + button on

the bottom, or the minus button on the top of the switch to select the proper ID.

Count the SCSI ID on each device in order from 0 to 15 on each SCSI bus to confirm that no two devices have the same ID number

assigned.

Note

The SCSI Host Adapter is normally set to SCSI ID 7, so this ID is

usually not available for a device.

SCSI ID Switch

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 64 65

No comments

Quantum 200D/400D User's Guide Page 24