Quantum 200D/400D User's Guide download pdf (Page 17)

Introduction 5

Rear Panel Controls and Connectors

Figure 1-2 shows the controls and connectors located on the rear panel of the LTO standalone.

Figure 1-2 LTO Standalone Rear Panel

Table 1-2 Rear Panel Controls and Connectors

Control or Connector Purpose

Power Switch

Turns power to the unit on and off.

AC Power Connector

Receptacle for AC power cord.

SCSI Connectors

Connections for the interface cable that connects the unit with the host computer

and/or to other devices on the SCSI channel. The interface cable can be attached

to either connector.

Your LTO standalone is equipped with a 68-pin high density SCSI device

connector.

SCSI ID Switch

Used to select the SCSI ID for the LTO drive. Factory set at 0.

LTO Tape Cartridges

To ensure that your LTO standalone conforms to ADIC specifications for reliability, use industry-approved LTO Ultrium tape cartridges.

Other certified LTO Ultrium data cartridges supported by your LTO standalone include: 10GB, 30GB, and 50GB.

Environmental and Shipping Information

Whenever possible, store LTO Ultrium Tape Cartridges in the following room-environment conditions:

Temperature of 20°C, to 5°C (68°F, to 9°F)

Relative humidity of 50% (20%)

AC Power Connector

SCSI Connectors

Power Switch

SCSI ID Switch

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 64 65

No comments

Quantum 200D/400D User's Guide Page 17