Quantum SuperLoader 3 User Manual download pdf (Page 7)

Tape Stuck in Drive 7

Quantum SuperLoader 3

9 If the tape is successfully removed, reinstall the magazine or magazines into the unit

and power up the unit.

Normal operation of the unit should occur.

If the tape is not removed successfully, proceed to Tape Stuck in Drive below.

Tape Stuck in Drive

1 Inspect for tape location. Using a paper clip or the corner of a plastic card, open the

mail slot door by gently pulling the bottom of the door towards the front of the

unit. Through the mail slot door, look for any labels that may be stuck above, below,

or in front of the cartridge such as that shown in Figure 8 below.

2 Remove any cartridge labels stuck in the drive. If you cannot reach the label with

your hand, refer to Tape Removal - Removing Top Cover on page 10.

Note: Figure 8 and Figure 9 are examples of labels causing a stuck tape condition.

Figure 8 Stuck Label Viewed

Through Mail Slot

Figure 9 Label Causing a Stuck

Tape

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

No comments

Quantum SuperLoader 3 User Manual Page 7