Quantum SuperLoader 3 User Manual download pdf (Page 4)

4 Tape Removal Without Removing the Top Cover

SuperLoader 3 Stuck Tape Removal Instructions

Tape Removal Without Removing the Top Cover

This procedure involves removing the magazine(s) and/or the magazine blank and

manually rotating the turntable.

1 Power off the system using the power switch located at the rear of the system.

2 Inspect for tape location. Using a paper clip or the corner of a plastic card, open the

mail slot door by gently pulling the bottom of the door towards the front of the

unit. Determine where the tape is located. The tape could be in the turntable, the

magazine, stuck between the magazine and the turntable, stuck between the

turntable and the tape drive or in the tape drive. If the tape is stuck in the drive,

proceed to Tape Stuck in Drive on page 7.

3 If the unit contains a magazine blank (typically on the right side of the unit), gently

remove the blank by pulling on the handle.

4 Remove the magazine(s) left and/or right - proceed to Manual Magazine Ejection

below.

Manual Magazine

Ejection

To manually eject the magazine:

1 Slide a plastic card on the front inside edge of the magazine between the magazine

and the front panel (see Figure 4).

Figure 4 Manually Ejecting the

Magazine

1 2 3 4 5 6 7 8 9 ... 17 18

No comments

Quantum SuperLoader 3 User Manual Page 4