Quantum Pathlight VX User's Guide Page 41

  • Download
  • Add to my manuals
  • Print
  • Page
    / 190
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 40
Pathlight VX User’s Guide 35
3 Enter valid values in the fields on the Setup - E-mail Configuration screen and click Apply.
The Progress Window appears and displays the status of the selected process.
If Success is shown in the Progress Window: The e-mail settings for the Pathlight VX were
successfully configured.
If Failure is shown in the Progress Window: The e-mail settings for the Pathlight VX were not
configured. To view the troubleshooting procedures, click View Recommended Actions. To view
the error details, click Error Logs for information on why the e-mail settings were not configured.
To re-configure the e-mail settings for the Pathlight VX, repeat Step 1
through Step 3.
4 Close the Progress Window.
Enabling the Support Notification
When enabled, the Pathlight VX Support Notification feature sends an e-mail to ATAC when problems occur
in the Pathlight VX. The support notification can be enabled or disabled, but ATAC’s notification address
([email protected]) cannot be deleted from the System Email Notifications screen.
1 From the menu bar, select Setup Notification.
The Setup - System E-mail Notifications screen appears. If e-mail settings have not been configured
for the Pathlight VX, you are prompted to configure them before enabling the support notification. Refer
to Configuring E-mail Settings for the Pathlight VX
on page 34.
3 Verify that the support notification works properly by sending a test notification.
a. Click the Test button to the right of [email protected] to send a test notification to ATAC.
b. Contact ATAC to determine if they received the test notification. If ATAC received the test
notification, go to Step 4
on page 36. If ATAC did not receive the test notification, perform these
steps:
1 If a relay mail server is used and a host name was specified for the relay server, specify an
IP address instead; the Hostname may not be resolved properly.
2 If a relay mail server is used, verify the DNS parameter in the Pathlight VX’s network
settings to be sure the Hostname is resolved properly. Refer to Changing Network Settings
on page 31.
3 Repeat Step 2
and Step 3. Contact ATAC to determine if the test notification was received.
Note
Once the Progress Window appears, you cannot cancel or stop this action.
However, you can close the window by clicking on the X in the upper-right of
the screen, but confirmation of success or failure is NOT shown.
Page view 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 189 190

Comments to this Manuals

No comments