Quantum DLT RACK 1 Installation Guide download pdf

Using the Rack Mount Kit To Install the

DLT Rack1 Chassis in an Equipment Rack

Step 1

Remove the chassis members from the slides and attach the chassis members to the chassis. Use

(4) M3 × 4 mm pan-head PHILLIPS

screws. See Figure 1.

Step 2

Loosely mount the left and right cabinet

section/bracket assemblies into the rack

between the upright rails (see Figure 2).

Use these screws and washers:

• (4) #10–32 × 3/8 pan-head PHILLIPS

screws

• (4) #10 flat washers.

(Left-side assembly shown; right-side

assembly is opposite.)

Note: Do not fully tighten the screws

between the rack and the bracket at this

time. After loosely installing both brackets

in the rack, securely tighten the rear bracket

screws onto the slide.

Step 3

Install the chassis assembly (from Step 1) into the cabinet sections:

a. Move the ball retainers in the cabinet sections to the fully forward position.

b. Slide the chassis sections through the plastic lead-in guides at the front of the cabinet sections

and into the balls.

c. Make sure that the chassis sections are both fully engaged with the balls in the ball retainers.

d. Press to release the lock on each slide, then fully close the slides.

Step 4

Align the slides:

a. Open and close the slides twice, making sure the chassis sections engage in the cabinet sections

properly and that the locks function properly.

b. Securely tighten the front bracket screws onto the slide.

Reproduction in any manner without the prior written permsision of Quantum Corporation is strictly prohibited.

Trademarks: Quantum is a trademark of Quantum Corporation, registered in the U.S.A. and other countries. Other trademarks and trade

names may be used in this document to refer to either the entities claiming the marks and names or their products. Quantum Corporation

disclaims any proprietary interest in trademarks and trade names other than its own.

Part Number 81-81209-02 Rev A01

*81-81209-02*

Chassis

Figure 1

Chassis member

Figure 2

Upright rails

Cabinet section/bracket assembly

1 2

*81-81209-02* 1

Summary of Contents

Page 1 - *81-81209-02*

Using the Rack Mount Kit To Install the DLT Rack1 Chassis in an Equipment RackStep 1Remove the chassis members from the slides and attach the chassis

Page 2

Using the Rack Mount Kit To Install the DLT Rack2 Chassis in an Equipment RackStep 1Remove the chassis members from the slides and attach the chassis

Comments to this Manuals

No comments

Quantum DLT RACK 1 Installation Guide

Browse online or download Installation Guide for Rack accessories Quantum DLT RACK 1. Quantum DLT RACK 1 Installation Guide User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Rack accessories Quantum DLT RACK 1